1. You'll find your cabin amidships.

2. Our cabin is amidships.

3. Six passengers can be berthed amidships.

4. The ferry hit us amidships.

5. WE'RE GONNA NEED COVER, THOUGH, STARBOARD AMIDSHIPS. SLATTERY:

6. At 11:09 p.m. the Stockholm struck the Italian liner amidships.

7. Stand ready to fire as soon as we've come amidships!

8. Then it struck the raft amidships and disappeared from view for a moment.

9. A porthole was opened amidships and on a plank lay the small body.

10. The worst situation was amidships, by the base of the mainmast.

11. Subdivision load lines assigned and marked on the ship’s side at amidships

12. Usually, they had a single mast stepped amidships and were rigged with a single square sail.

13. The flight deck control post, where I sat, was situated on the port side, amidships.

14. Provision was also made for two other Lewis guns, one amidships and one in the tail.

15. Draught is the vertical distance from the moulded base line amidships to the subdivision load line in question

16. Usually(http://Sentencedict.com), they had a single mast stepped amidships and were rigged with a single square sail.

17. In the late 19 th century, engines were placed in front , amidships, and at the rear.

18. The cat, although nervous, appears unharmed by the tennis ball which has just struck it amidships.

19. The sensor system shall be installed as far as possible amidships, horizontal and aligned with the ship's fore-and-aft-line.

20. - in the case of vessels not intended for the carriage of goods, one pair of marks roughly amidships suffice.

21. There was a low deckhouse amidships with an upper wheel and emergency tiller steering from a small cockpit aft.

22. in the case of vessels not intended for the carriage of goods, one pair of marks roughly amidships suffice

23. .4 Draught is the vertical distance from the moulded base line amidships to the subdivision load line in question.

24. Plasma etched through the meters of titanium-A armor plating like a blowtorch through rice paper, and her center amidships decks vented.

25. The sensor system shall be installed as far as possible amidships, horizontal and aligned with the ship’s fore-and aft-line.

26. The sensor system shall be installed as far as possible amidships, horizontal and aligned with the ship's fore-and aft-line.

27. Nautical A fore-and-aft rigged sailing vessel with at least two masts, a foremast, and a mainmast stepped nearly amidships.

28. Every vessel must have at least three pairs of draught marks, one pair amidships and the others approximately one-sixth of the vessel

29. It may be reduced by 15 % where the vessel is equipped with only a single bow anchor and the hawse pipe is located amidships.

30. .1In order that the required degree of subdivision shall be maintained, a load line corresponding to the approved subdivision draught shall be assigned and marked on the ship's sides amidships.

31. Subdivision load lines assigned and marked on the ship's side at amidships (Regulation II-1/B/11)Freeboard (in mm)Remarks with regard to alternative service conditions:C.1 (1)

32. 3. In ships of 76 metres in length and upwards, a double bottom shall be fitted amidships, and shall extend to the fore and after peak bulkheads, or as near thereto as practicable.

33. .4In ships of 76 metres in length and upwards, a double bottom shall be fitted amidships and shall extend to the fore and after peak bulkhead or as near thereto as practicable.

34. .1 In order that the required degree of subdivision shall be maintained, a load line corresponding to the approved subdivision draught shall be assigned and marked on the ship’s sides amidships.

35. On-screen, the Stalingrad took a direct hit on her port side. Plasma etched through the meters of titanium-A armor plating like a blowtorch through rice paper, and her center amidships decks vented.

36. 15 On-screen, the Stalingrad took a direct hit on her port side. Plasma etched through the meters of titanium-A armor plating like a blowtorch through rice paper, and her center amidships decks vented.

37. .3 In ships of 76 metres in length and upwards, a double bottom shall be fitted amidships, and shall extend to the fore and after peak bulkheads, or as near thereto as practicable.

38. While the dromōn was developed exclusively as a war galley, the chelandion would have had to have a special compartment amidships to accommodate a row of horses, increasing its beam and hold depth.

39. Reloading his bow tubes, he doubled back and fired a salvo of three torpedoes, all at Royal Oak, This time he was successful: at 01:16 all three struck the battleship in quick succession amidships and detonated.

40. The freeboard measured amidships from the edge of the working deck from which fishing is undertaken, shall not be less than # mm or not less than the freeboard corresponding with the maximum permissible draught, whichever is the greater

41. The freeboard measured amidships from the edge of the working deck from which fishing is undertaken, shall not be less than 300 mm or not less than the freeboard corresponding with the maximum permissible draught, whichever is the greater.

42. Such protection will be deemed satisfactory if the line of intersection of the outer edge of the margin plate with the bilge plating is not lower at any part than a horizontal plane passing through the point of intersection with the frame line amidships of a transverse diagonal line inclined at 25 ° to the base line and cutting it at a point one half of the ship's moulded breadth from the middle line.

43. Such protection will be deemed satisfactory if the line of intersection of the outer edge of the margin plate with the bilge plating is not lower at any part than a horizontal plane passing though the point of intersection with the frame line amidships of a transverse diagonal line inclined at 25 ° to the baseline and cutting it at a point one half the ship's moulded breadth from the middle line.

44. Such protection will be deemed satisfactory if the line of intersection of the outer edge of the margin plate with the bilge plating is not lower at any part than a horizontal plane passing through the point of intersection with the frame line amidships of a transverse diagonal line inclined at 25 degrees to the base line and cutting it at a point one-half the ship's moulded breadth from the middle line.